How to make 24v and 10amp power supply easy at home

In this project we learn how to make 24v and 10amp power supply easy at home with the help of circuit diagram and few simple steps.

In this project we learn how to make 24v and 10amp power supply easy at home with the help of circuit diagram and few simple steps. in this project we also use lm7824 voltage regulator for regulate voltage. for making this project we need some components.

Components:

24v 10amp transformer
Tip3055 transistor
LM7818 Voltage regulator
Heat sink
10A10 Diode (2)
1N4007 Diode
50v, 4700uf capacitor
50v 470uf capacitor
PCB Board
Soldering Iron
Soldering Wire

now following few simple steps.

take a 24v 10 amp transformer, we can use 12v two output transformer.
Transformer has 2 side, (Primary and Secondary)

24v 10 amp power supply circuit diagram
Primary side use for 220 volt input power supply.
Secondary side has 3 wires.
10A10 diode connect with 1st and 3rd wires of transformer.
And 2nd sides of both diodes connect with each other.
Transformer middle or center wire use for ground wire or negative wire.
Now connect positive side of 4700 micro farad capacitor with 2nd sides of diode, and negative side connect with ground wire of transformer.
And now connect input wire of voltage regulator with positive wire of 4700 micro farad capacitor,
Now connect 1N4007 diode with ground wire of voltage regulator like diagram,
And now output wire of voltage regulator connect with base of transistor,
Now collector pin of transistor connect with positive side of 4700 micro farad capacitor,
And now positive side of 470 micro farad capacitor connect with emitter pin of transistor and negative side connect with ground wire.
Finally emitter pin of transistor use for positive output and ground wire use for negative output.